![]() ![]() The same Vertical and falat jaws are strengthened by end gussets. There is slot 43L x 15W on centre in the bottom part of the(55W) jaw. The Jaw is 65 H x 55W x 95 L and about 8mm or therebouts in wall thickness. Hi Bob, I am pretty sureyour BS is the model the Chinese copied and H &F sell as the BS4E or B002. Had a bit of an incident unloading it, yep turned ugly, and it sustained a bit of damage. Those metal saws would have to be one of the worst things I've ever loaded/unloaded off the ute tray - weighty, narrow wheels, top heavy, pivoting arm that springs up, all waiting to catch you out. I have to strip it down pretty well anyway. I will remove the cover and have a look at the setup. I thought I read a thread back aways, where the backlash could be shimmed out with a bush or some such to prevent the gears tearing themselves up when they got sloppy. PS I will probably put on a larger motor as it's only a piddling 1/3 HP. Also I remember something about a mod to take backlash out of the gearbox - what was that all about? A spacer on the pinion shaft? Any help appreciated. 18 Yes the rust was free, but for $85 I didn't think it was too bad. Some photo's of the missing parts would be handy. Anyone else got one of these? I picked this up one cheap recently and it's mostly all there, except for the right angle vise jaw that attaches to the thread and handle. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |